Sponsor Banner Go Fast Bits Castrol Edge Super Cheap Auto Haltech Bridgestone RE003 Ryobi Tools Century Batteries


No announcement yet.

Need help wiring Autogauge Vacuum gauge

  • Filter
  • Time
  • Show
Clear All
new posts

  • Need help wiring Autogauge Vacuum gauge

    Hi everyone, i just pick up this vacuum gauge from scrap. I have no sensors for the gauge and i read somewhere that it is possible to tap the signal from my MAP sensor. The problem is now that i cant figure the connection for the top middle port. If it is possible, how can i wire up the signal to from the MAP sensor to the gauge?? I have attach the MAP sensor below, it is a 4pin sensor. Thanks in advance

  • #2
    the question is, do you have the molux plugs that go into the back of the Gauge. If not call Autogauge to get a intall kit.
    1991 Bronco Eddie Bauer ~ 351w EFI 5.8 (5752cc) ~ E4OD ~ BW1356 (Manual) ~ Manual Hub{s} ~ 265/75 r15